Arm rail on straight kegger.

[tnchapma]

Finished the back bar, modded to suit the height I had available and customised it a little elsewhere. Now about to build the straight kegger. Going to make it 10ft long though and will be fitting against the wall one side. Just reviewing the plans. Question is. I would like to use the nice arm rail on it like the 45 degree bar and it appears that this bar does not have it. Are there any mods I need to make at the bar top end of things for it to fit the arm rail nicely ??? Looks like the 45 degree bar has 3 layers of 3/4 inch height and the arm rail fits nicely over it. The straight kegger appears not to have this ???
Any and all help and suggestions will be greatly appreciated. Buying materials in a day or 2 and hoping to have the “Pub” open for St Patricks Day.

Paul.

[young4u_]

I used a bar rail from Denoon lumber and it turned out pretty good. There’s pictures of it on here. I didn’t really follow the plans much when it came to the bar top. I just built it the way I wanted it and made a lip for the bar rail to sit on. I’m definitely glad I went this route instead of using the rectangular rail that the plans call for. My bar rail is very comfortable on the arms!

[tnchapma]

Thanks so much for the help and information. I will likely build to the bar top part and adapt as necessary from there. Without doubt want the nice looking arm rail that you have used and recommended.
Will post photos during and after construction.

[tnchapma]

Just finishing my bar top now. Arm rail in process. Will post photos of the finished result (and the in process) when completed.

[Author]

Posts