Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Padded arm rail photos #20363 Score: 0

    I would very much like to see the photos of the brackets you are talking about for future use. Since I have the bar base and beer gutter already installed its a little late for me to make changes now.

    I however can still make some changes such as putting an angle on the bar top decking, and then a support piece like you have in your first post. however I cannot see the second post pictures at all, can you please re post them or send them to me at oakspsd@yahoo.com.

    Thanks for the help.

    in reply to: Where to buy Foam & Vinyl covering #20369 Score: 0

    I am making a bar for a friend and he is paying for good materials to be used. It is a smaller bar and a pic he showed me of one he liked has padded rails. I set aside three inches for the bar rail on the base of the bar top and will place a piece of 3/4 inch oak at the edge of the granite top to keep any spills from getting to the decking.

    Looking at your picture I am seeing that you have a steep angle, I may use that idea to put a small angle on the padded rail but am thinking that since mine will be smaller I might merely make a 45 degree angle on the edge of the 3/4 inch plywood to take down the corner of the area being leaned against.

    You mentioned leather, is leather going to be over the top in price? This bar is only five foot top with two foot depth on the sides so I would like to use leather if at all possible. Would Naugahyde be better than vinyl?

    in reply to: 45 degree bar plans #20372 Score: 0

    I have found them thanks

    in reply to: 45 degree bar plans #20380 Score: 0

    Did your 45% corners look like the posting I put up?

    in reply to: 45 degree bar plans #20379 Score: 0

    I am looking for a straight bar with 45% front corners and cannot find anything like that on the site. I read where you said you have some detailed pics on the builders forum but cannot find them. Can you please tell me how to bring them up?

    I am trying to make something with this shape.

    http://www.brookstone.com/webassets/product_images/700×700/691261p.jpg

Viewing 5 posts - 1 through 5 (of 5 total)
Easy Home Bar Plans