- This topic has 0 replies, 1 voice, and was last updated 11 years, 2 months ago by .
Viewing 1 post (of 1 total)
-
Posts
-
Im looking to do a combination of the two. It will be approximately 5’x8′. I tried the chbd of the 45 bar but it wont let me get to the dimensions I need since I cant resize the middle section. I need to get the bar build going as soon as possible. Any recommendations? I did it on the L Shaped designer. If I were doing it on that it would be 34″ on the short side and 74″ on the long side, but im not sure how this might change the construction and lumber measurements if I put the 45 on the corner? PLEASE HELP?!
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.