fbpx

Fitting a kegerator into the keg box section

Home Bar Forum Forums Home Bar Project Construction Questions EHBP-04 L-Shaped Kegger Bar Fitting a kegerator into the keg box section

Tagged: 

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #31028 Score: 0
    bpwdmin
    Keymaster
    2 pts

    Some have asked if a kegerator will fit into the end module that is intended for the DIY keg box.
    The short answer is Yes.

    Most kegerators, like http://www.amazon.com/Nostalgia-KRS2100-Cubic-Foot-Kegorator-Dispenser/dp/B000HJVYDQ
    will fit at 20.3″d x 26″w x 32″ high.

    The opening is about 27″ wide x 24″ deep x 31.75″ high – before adding final trim.
    So, you may have to trim the trim back a little to get enough opening, maybe not.

    It is suggested you put the kegerator in place before completing the top framing of the keg box area. Otherwise you may have to tip the keg box to get it in.
    Removing coasters and top racks will buy even more vertical space.

Viewing 1 post (of 1 total)
  • You must be logged in to reply to this topic.