- This topic has 1 reply, 2 voices, and was last updated 16 years, 10 months ago by .
-
Posts
-
Hey everyone, need some help A.S.A.P. I am trying to tap my keg using CO2 and am having problems. I am following the directions from http://www.kegworks.com, but I am not sure where the “adjustment screw” is. I have identified the drum screw (big bolt on front of regulator) but it says I am supposed to have a P.S.I of 10-12 before I attach the coupler to the keg and turn on the gas, but I am unassure how to do this. Any help would be appreciated, I have the keg and my mouth is watering, need help A.S.A.P.
oh man that is a bad feeling…full keg on ice and no way to get the nectar out of her! I would check out http://www.micromatic.com for info. It is a phenomenal site for all bar related supplies and information. I know on my reg. I had to back out the screw on the front all the way out to get pressure once I hooked my tank on and then set it to the right psi. Did your reg come with a packet?
BEst of luck!
- You must be logged in to reply to this topic.